Configuring Trunk Groups and Dynamic Link Aggregation
5 - 15
To display trunk group information for specific ports, enter a command such as the following:
The display is divided into sections for configured trunks and operational trunks. A configured trunk group is one
that has not been activated yet.
Table 5.3 describes the information displayed by the show trunk command.
Table 5.3: CLI Trunk Group Information
This Field... Displays...
Trunk ID The trunk group number. The software numbers the groups in the
display to make the display easy to use.
Type The type of trunk group, which can be one of the following:
• Server – The trunk group is connected to a server.
• Switch – The trunk group is connected to another Routing Switch.
HP9300(config)# show trunk ethernet 1/1 to 1/8
Configured trunks:
Trunk ID: 1
Type: Switch
Ports_Configured: 8
Primary Port Monitored: Jointly
Ports 1/1 1/2 1/3 1/4 1/5 1/6 1/7 1/8
Port Names none none none none none longna test none
Port_Status enable enable enable enable disable disable enable enable
Monitor on on off on off off off off
Mirror Port 3/3 3/4 N/A 3/5 N/A N/A N/A N/A
Monitor Dir both in N/A out N/A N/A N/A N/A
Operational trunks:
Trunk ID: 1
Type: Switch
Duplex: Full
Speed: 1G
Tag: No
Priority: level0
Active Ports: 6
Ports 1/1 1/2 1/3 1/4 1/5 1/6 1/7 1/8
Link_Status active active active active down down active active
Load Sharing
Mac Address 3 2 2 2 0 0 6 1
IP 0 0 0 0 0 0 0 0
IPX 0 2 1 0 0 0 0 1
Apple Talk 1 2 0 4 0 0 0 3
Multicast 4 2 5 2 0 0 2 3
To Next Page
Loading...
