HP A3100-8 v2 SI User Manual

NOTE:
After enabling MAC-based VLAN on the switch, you must configure related authentication settings on the
access authentication server. For more information about 802.1X authentication, see the
Security
Configuration Guide
.
Follow these steps to configure dynamic MAC-based VLAN:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet
interface view
interface interface-type
interface-number
Enter
Ethernet
interface
view or port
group view
Enter port
group view
port-group manual port-group-name
Use either command.
• The configuration made in
Ethernet interface view applies
only to the current port.
• The configuration made in port
group view applies to all ports in
the port group.
Configure the link type of the
port(s) as hybrid
port link-type hybrid Required
Enable MAC-based VLAN mac-vlan enable
Required
Disabled by default
MAC-based VLAN configuration example
Network requirements
• As shown in Figure 32, Ethernet 1/0/1 of Device A and Device C are each connected to a meeting
room. Laptop 1 and Laptop 2 are used for meetings and might be used in either of the two meeting
rooms.
• Different departments own Laptop 1 and Laptop 2. The two departments use VLAN 100 and VLAN
200 respectively. Each laptop must be able to access only its own department server, no matter
which meeting room it is used in.
• The MAC address of Laptop 1 is 000d-88f8-4e71, and that of Laptop 2 is 0014-222c-aa69.
105

HP A3100-8 v2 SI Specifications

General

Brand	HP
Model	A3100-8 v2 SI
Category	Switch
Language	English