HP A3100-8 v2 SI User Manual

Displaying and maintaining Ethernet link
aggregation
To do... Use the command... Remarks
Display information for an
aggregate interface or multiple
aggregate interfaces
display interface bridge-aggregation [ brief
[ down ] ] [ | { begin | exclude | include }
regular-expression ]
display interface bridge-aggregation
interface-number [ brief ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display the local system ID
display lacp system-id [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display the global
link-aggregation load-sharing
criteria
display link-aggregation load-sharing mode [ |
{ begin | exclude | include } regular-expression ]
Available in any view
Display detailed link aggregation
information on link aggregation
member ports
display link-aggregation member-port
[ interface-list ] [ | { begin | exclude | include }
regular-expression ]
Available in any view
Display the summary of all
aggregation groups
display link-aggregation summary [ | { begin |
exclude | include } regular-expression ]
Available in any view
Display detailed information about
a specific or all aggregation
groups
display link-aggregation verbose
[ bridge-aggregation [ interface-number ] ] [ |
{ begin | exclude | include } regular-expression ]
Available in any view
Clear LACP statistics for a specific
or all link aggregation member
ports
reset lacp statistics [ interface interface-list ]
Available in user
view
Clear statistics for a specific or all
aggregate interfaces
reset counters interface [ bridge-aggregation
[ interface-number ] ]
Available in user
view
Ethernet link aggregation configuration examples
NOTE:
In an aggregation group, only ports that have the same port attributes and class-two configurations
(see ”Configuration classes”) as the reference port (see “Reference port”) can operate as Selected ports.
You must ensure that all member ports have the same port attributes and class-two confi
g
urations as the
reference port. The other settings only need to be configured on the aggregate interface, not on the
member ports.
Layer 2 static aggregation configuration example
Network requirements
As shown in Figure 8:
• Device A and Device B are connected through their respective Layer 2 Ethernet interfaces Ethernet
1/0/1 through Ethernet 1/0/3.
38

HP A3100-8 v2 SI Specifications

General

Brand	HP
Model	A3100-8 v2 SI
Category	Switch
Language	English