HP A3100-8 v2 SI User Manual

Table 6 Features incompatible with Layer 2 aggregation groups
Feature Reference
MAC authentication MAC authentication configuration in the Security Configuration Guide
Port security Port security configuration in the Security Configuration Guide
IP source guard IP source guard configuration in the Security Configuration Guide
802.1X 802.1X configuration in the Security Configuration Guide
NOTE:
• If a port is used as a reflector port for port mirroring, do not assign it to any aggregation group. For
more information about reflector ports, see the
Network Management and Monitoring Configuration
Guide
.
• To achieve better load sharing results for data traffic among the member ports of a link aggregation
group, assign ports of the same type (such as all 100 Mbps
ports or all GE ports and so on) to the link
aggregation group.
CAUTION:
Removing an aggregate interface also removes the corresponding aggregation group. At the same time,
all member ports leave the aggregation group.
Configuring a static aggregation group
NOTE:
To guarantee a successful static aggregation, ensure that the ports at both ends of each link are in the
same aggregation state.
Follow these steps to configure a Layer 2 static aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view
interface bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Exit to system view quit —
Enter Layer 2 Ethernet interface
view
interface interface-type
interface-number
Assign the Ethernet interface to the
aggregation group
port link-aggregation group
number
Required
Repeat these two steps to assign
multiple Layer 2 Ethernet interfaces
to the aggregation group.
Configuring a dynamic aggregation group
33

HP A3100-8 v2 SI Specifications

General

Brand	HP
Model	A3100-8 v2 SI
Category	Switch
Language	English