HP A3100-8 v2 SI - Configuring Load Sharing for Link Aggregation Groups; Configuring Load-Sharing Criteria for Link Aggregation Groups

To do... Use the command... Remarks
Enter system view system-view —
Enter aggregate interface view
interface bridge-aggregation
interface-number
—
Restore the default settings for the
aggregate interface
default Required
Configuring load sharing for link aggregation
groups
Configuring load-sharing criteria for link aggregation groups
You can determine how traffic is load-shared across a link aggregation group by configuring
load-sharing criteria. The criteria can be IP addresses, MAC addresses, or any combination.
Follow these steps to configure global link-aggregation load-sharing criteria:
To do... Use the command... Remarks
Enter system view system-view —
Configure the global
link-aggregation load-sharing
criteria
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
source-ip | source-mac } *
Required
By default, the global
link-aggregation load-sharing
criteria include the source MAC
address for Layer 2 packet types
such as ARP, and the source and
destination IP addresses for Layer 3
packet types such as IP packets.
You can set the following global aggregation load-sharing criteria:
• Source IP address
• Destination IP address
• Source MAC address
• Destination MAC address
• Source IP address and destination IP address
• destination MAC address and source MAC address
37