To do… Use the command… Remarks
Create a protocol template for the
VLAN
protocol-vlan [ protocol-index ]
{ at | ipv4 | ipv6 | ipx { ethernetii
| llc | raw | snap } | mode
{ ethernetii etype etype-id | llc
{ dsap dsap-id [ ssap ssap-id ] |
ssap ssap-id } | snap etype
etype-id } }
Required
Exit VLAN view quit Required
Enter Ethernet
interface view
interface interface-type
interface-number
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter interface
view or port
group view
Enter port group
view
port-group manual
port-group-name
Required
Use either command.
• In Ethernet interface view, the
subsequent configurations
apply to the current port.
• In port group view, the
subsequent configurations
apply to all ports in the port
group.
• In Layer 2 aggregate
interface view, the
subsequent configurations
apply to the Layer 2
aggregate interface and all
its member ports.
Configure the port link type as hybrid
port link-type hybrid Required
Configure current hybrid port(s) to
permit the packets of the specified
protocol-based VLANs to pass through
port hybrid vlan vlan-id-list
{ tagged | untagged }
Required
By default, all hybrid ports
permit only packets of VLAN 1 to
pass through.
Associate the hybrid port(s) with the
specified protocol-based VLAN
port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-end ] | all }
Required
109