EN
Removing Covers
6-7
Top Cover
Open the Top Cover and remove the Toner Cartridge.
CAUTION
To prevent damage to the Toner Cartridge, do not expose it to light for
more than a few minutes.
To remove the Top Cover, you must remove the Rear Right Side
Cover (page 6-6), the Toner Cartridge Drive Arm (page 6-9), the
Control Panel Overlay and the Control Panel (below).
Control Panel Overlay
Figure 6-3
Removing the Control Panel Overlay
1. Using a flat-blade screwdriver, gently pry upward on the right side
of the Control Panel Overlay to loosen it.
2. Remove the Control Panel Overlay from the tabs on the left and
lift it upward, off of the printer.
To Next Page
Loading...