6-20 Removing and Replacing Parts
EN
Formatter Cage Assembly
Figure 6-16 Removing the Formatter Cage Assembly
1. Print a Configuration Page. The information is necessary to
reconfigure the printer after you replace the Formatter.
2. Remove the Rear Right Side Cover (page 6-6). The Formatter
Cage Assembly is directly underneath.
3. Remove the captive screw and open the DIMM access door to
see if any DIMMs are installed. Remove and transfer any DIMMs
or EIO accessories if you replace the Formatter.
4. Remove the 5 screws around the Formatter Cage.
5. Slide the Formatter toward the rear of the printer and remove it.
Note Using the Configuration Page you printed in step 1above, reconfigure
the printer after replacing the Formatter. Be sure to reset the printer’s
page count (page 4-5).
For accessing DIMMs
EIO
accessory
To Next Page
Loading...