6-40 Removing and Replacing Parts
EN
Gear Train
Figure 6-37 Removing the Gear Train
1. Remove the following Covers (starting on page 6-6): Top Cover,
Front Right Side Cover, Rear Cover/Rear Output Bin, and Tray 1.
Remove the Right Side Toner Cartridge Guide (page 6-33), the
Registration Assembly (page 6-34), the Formatter Cage
Assembly (page 6-20), and the Formatter Pan (page 6-39). The
Gear Train is on the right side of the printer.
2. If the Registration Assembly has not already been removed, take
out the rearmost silver screw under the green handle (page
6-35).
3. Remove the 8 black self-tapping screws.
4. Pull the Ribbon Cable Assembly outward (off the pin), then down,
out of the way.
5. Remove any remaining wires from the white plastic guide.
6. Slide out the Gear Train.
Note When you reinstall the Gear Train, slide the top in first and then push
the bottom in.
Step 4
Toner Cartridge Drive Arm
To Next Page
Loading...