HP LaserJet 4000 - Preventative Maintenance

EN
Preventative Maintenance
4-5
Preventative Maintenance
The preventative maintenance cycle for this printer is every 200,000
pages. To order the maintenance kit see page 8-2. The kit contains
the following replacement parts: one Fuser, one Transfer Roller, one
Tray 1 Roller, three Feed Rollers, and three Separation Rollers. Refer
to the instructions included in the kit for detailed replacement
procedures.
Reset Maintenance Count
After the PM kit has been installed, reset the maintenance count.
1. Turn the printer off.
2. While pressing
[Item-]
and
[Value-]
turn the printer on.
Reset Maintenance Count appears, followed by
INITIALIZING
. After
a few seconds
READY
appears.
Expected Life of Components
The following table shows the expected life of certain components in
the printer. To order parts, see Chapter 8.
Table 4-2. Life of Components
No. Part name Part No. Quantity Expected Life
1 Tray 1 Pickup Roller RG5-3718-000 1 100,000 pages
2 Tray Feed Roller RF5-2490-000 1 200,000 pages
3 Tray Separation Roller RF5-2490-000 1 200,000 pages
4 Tray 1 Separation Pad RB1-8873-000 1 200,000 pages
5 Tray 1 Pickup Solenoid RH7-5172-000 1 200,000 pages
6 Fuser
100-127V
220-240V
C4118-69003
C4118-69004
1
1
200,000 pages
200,000 pages