EN
Paper Specifications
1-15
Labels
CAUTION
To avoid damaging the printer, use only labels recommended for use
in laser printers.
If you have problems printing labels, use Tray 1 and open the rear output
bin.
Never print on the same sheet of labels more than once.
Label Construction
When selecting labels, consider the quality of each component:
z
Adhesives:
The adhesive material should be stable at 400° F
(205° C), the printer’s maximum temperature.
z
Arrangement:
Only use labels with no exposed backing between
them. Labels can peel off of sheets that have spaces between the
labels, causing serious jams.
z
Curl:
Prior to printing, labels must lie flat with no more than 0.5 in
(13 mm) of curl in any direction.
z
Condition:
Do not use labels with wrinkles, bubbles, or other
indications of separation.
Transparencies
Transparencies used in the printer must be able to withstand 400° F
(205° C), the printer’s maximum temperature. For best results, close
the rear output bin to print transparencies to the top output bin.
CAUTION
To avoid damaging the printer, use only transparencies recommended
for use in laser printers.
If you have problems printing transparencies, use Tray 1.
To Next Page
Loading...