EN
Service Mode
3-33
Maintenance Page Count
The maintenance page count should be reset only after a
maintenance kit has been installed.
This will reset the maintenance counter so that the message
PERFORM
PRINTER MAINTENANCE
will display another 200,000 pages later
(default).
z
Hold down the
[Item-]
and
[Value-]
keys.
z
Turn the printer on.
z
Wait for
RESET MAINTENANCE COUNT
to be displayed and then
release both keys.
MAINTENANCE COUNT
in the Service Mode Menu sets the page count
interval at which the next service is due for the printer. This is set
initially at the factory to 200,000 pages. (For example, the message
displays at 200,000 pages. If the Printer Maintenance Kit is installed
at 200,114 pages, the message displays 200,000 pages later, at
400,114 pages.) Editing this number is similar to editing the
PAGES
item above.
Serial Number
If a Formatter is replaced, then the serial number must be reentered.
Editing this number is similar to editing the
PAGES
item above.
Cold Reset Paper
The default paper size is stored in NVRAM and when the printer is
cold reset, the default paper size is set to the factory setting. Possible
values are
COLD RESET PAPER=LETTER
and
COLD RESET PAPER=A4
.
When replacing the Formatter in countries that use A4 rather than
letter size paper, set the cold reset paper size to
A4
.
Diagnostics
This menu item enables or disables the use of the firmware diagnostic
features. Possible values are
DIAGNOSTICS=OFF*
and
DIAGNOSTICS=ON
. When enabled, the diagnostic features are
accessible when the printer is in the online
READY
state by pressing
the
[Select]
key.
Clear Event Log
This item allows the internal event log to be cleared.
To Next Page
Loading...