6-44 Removing and Replacing Parts
EN
Engine Controller Board
Note After you replace the Engine Controller Board, do not forget to readjust
the top margin as described on page 6-46.
1. Separate the Engine from the Paper Feed Module (page 6-42).
The Engine Controller Board is on the underside of the engine
and contains the following:
• DC Controller
• Hi-Voltage Power Supply
• AC Power Supply
• DC Power Supply
• Timing Controls
Figure 6-41 Removing the Engine Controller Board
2. Remove the Fuser Assembly (page 6-18).
Spring
Power
switch
rod
(In the back, not on the board)
To Next Page
Loading...