EN
Separating the Engine Module from the Paper Feed Module
6-47
Figure 6-44
Adjusting the Top Margin
2. Measure the distance between the edge of the paper and the
print pattern. Measure all the test prints and calculate the
average.
3. Adjust VR501 so that the margin becomes .08 inch
(2 millimeters). Turn VR501 clockwise to decrease the margin or
counter-clockwise to increase the margin.
4. Make several test prints again and perform step 2 above. If the
top margin is still incorrect, repeat the procedure.
Measure this distance
To Next Page
Loading...