HP LaserJet 4000 - Page 230

7-36 Troubleshooting
EN
53.xy.zz
PRINTER ERROR
There is a memory error
with an accessory. The
DIMM that caused the
error will not be used.
Values of
x
,
y
, and
zz
are
as follows:
x=DIMM type
0=ROM
1=RAM
y=Device location
0=internal memory
(ROM or RAM)
1 to 4=DIMM slots
1, 2, 3, or 4
zz=Error number
0=Unsupported memory
1=Unrecognized memory
2=Unsupported memory
size
3=Failed RAM test
4=Exceeded maximum
RAM size
5=Exceeded maximum
ROM size
6=Invalid DIMM speed
7=DIMM reporting
information incorrectly
8=DIMM RAM parity error
9=ROM needs to be
mapped to an
unsupported address
10=DIMM address conflict
11=PDC XROM out of
bounds
12=Unable to make a
temporary mapping
1. Turn the printer off, and
reseat or replace the
specified DIMM.
2. Try the DIMM in
another slot.
3. Replace the DIMM that
caused the error.
Table 7-6. Numerical Printer Messages (continued)
Control Panel
Message
Event Log
Message
Explanation Recommended
Action