Vertical repetitive defects
●
The print cartridge might be damaged. If a repetitive mark
occurs at the same spot on the page, install a new HP print
cartridge.
●
The internal parts might have toner on them. If the defects
occur on the back of the page, the problem will probably
correct itself after a few more printed pages.
●
In your printer driver, make sure the appropriate media type
is selected.
Misformed characters
●
If characters are improperly formed, producing hollow
images, the media stock might be too slick. Try a dierent
media.
●
If characters are improperly formed, producing a wavy
eect, the printer might need service. Print a conguration
page. If the characters are improperly formed, contact an
HP-authorized dealer or service representative.
Page skew
●
Make sure that the media is loaded correctly and the media
guides are no
t too tight or too loose against the media
stack.
●
The input bin might be too full.
●
Check the media type and quality.
Curl or wave
●
Check the media type and quality. Both high temperature
and high humidity cause media to curl
.
●
The media might have been in the input tray too long. Turn
over the s
tack of media in the tray. Also, try rotating the
media 180° in the input tray.
●
Open the straight-through output door and try printing
straigh
t through.
●
The fuser temperature might be too high. In your printer
driver, make sur
e the appropriate media type is selected. If
the problem persists, select a media type that uses a lower
fuser temperature, such as transparencies or light media.
96 Chapter 10 Solve problems ENWW
To Next Page
Loading...
Need help?
General
