HP LaserJet P2030 series User Manual

When connected with a USB cable, the product does not appear in the Macintosh Print Center after the driver is selected.
Cause Solution
This problem is caused by either a software or a hardware
component.
Software problem-solving
●
Check that your Macintosh supports USB.
●
Verify that you are using a Macintosh operating system that
this product supports.
●
Ensure that your Macintosh has the appropriate USB
software from Apple.
Hardware problem-solving
●
Check that the product is turned on.
●
Verify that the USB cable is connected correctly.
●
Check that you are using the appropriate high-speed USB
cable.
●
Ensure that you do not have too many USB devices drawing
power from the chain. Disconnect all of the devices from the
chain, and connect the cable directly to the USB port on the
host computer.
●
Check to see if more than two nonpowered USB hubs are
connected in a row on the chain. Disconnect all of the
devices from the chain and connect the cable directly to the
USB port on the host computer.
NOTE: The iMac keyboard is a nonpowered USB hub.
Solve Linux problems
For information about Linux problem solving, go to the HP Linux support Web site: www.hp.com/go/
linuxprinting.
104 Chapter 10 Solve problems ENWW

HP LaserJet P2030 series Specifications

General

Print Technology	Laser
Print Speed	Up to 30 ppm
Monthly Duty Cycle	Up to 25, 000 pages
First Page Out	As fast as 8 seconds
Internal Memory	16 MB
Processor Frequency	266 MHz
Standard Connectivity	Hi-Speed USB 2.0
Input Capacity	250 sheets
Media Sizes Supported	envelopes
Warm-up Time	8 seconds from Ready
Supported Operating Systems	Windows, Mac OS, Linux
Weight	10.0 kg
Print Resolution	Up to 1200 x 1200 dpi
Output Capacity	150-sheet output bin