100 • Configuring and Running SSH2 HP NonStop SSH Reference Manual
If omitted, value SHARED will be used, which was the value used prior to adding parameter
SFTPEXCLUSIONMODEREAD.
Example
SFTPEXCLUSIONMODEREAD EXCLUSIVE
SFTPIDLETIMEOUT
Use this parameter to control how long SFTPSERV keeps running without any SFTP protocol traffic before terminating
itself.
Parameter Syntax
SFTPIDLETIMEOUT <seconds>
Arguments
<seconds>
The time in seconds the SFTPSERV waits after the last SFTP command before it stops serving the client.
Considerations
• The SFTP client will not be able to issue further SFTP commands.
Default
If omitted, there is no SFTP idle timeout. The SFTPSERV will be running until the STP client ends the session.
Example
SFTPIDLETIMEOUT 180
SFTPMAXEXTENTS
Use this parameter to specify the MAXEXTENTS value for files that are created on the NonStop system.
Parameter Syntax
SFTPMAXEXTENTS maxextents
Arguments
maxextents
Specifies the value to be used.
Considerations
• The value can be overridden in "put" and "get" commands using the extended syntax described in "SFTP Client
Reference" chapter, in the section entitled "Extended Syntax for Creation of New Guardian Files".
Default
If omitted, SSH2 will use a value of 900.
Example
SFTPMAXEXTENTS 950
SFTPPRIMARYEXTENTSIZE
Use this parameter to specify the primary extent size for files that are created on the NonStop system.
To Next Page
Loading...
Need help?
General