HP NonStop SSH 544701-014 User Manual

HP NonStop SSH Reference Manual Configuring and Running SSH2 • 61
A number is used to represent a bit mask that controls the format. Following are the values and their
corresponding format:
Bit 1 (decimal 1) Date
Bit 2 (decimal 2) Header (log messages a pre-fixed with "[log]")
Bit 3 (decimal 4) Time
Bit 4 (decimal 8) Milliseconds
Bit 5 (decimal 16) Process ID (name or PIN)
Bit 7 (decimal 64) Log level of message
Default
The default log format is 21 (date, time, process name).
See also:
• AUDITFILE, AUDITFORMATCONSOLE, AUDITFORMATEMS
• "Audit Messages" in the chapter entitled "Monitoring and Auditing"
AUDITMAXFILELENGTH
Use this parameter to control the maximum size of an audit file.
Parameter Syntax
AUDITMAXFILELENGTH length
Arguments
length
A number representing the maximum log file length in kilobytes. Values must fall within the following
constraints:
Maximum: 40.000 or 40 MB
Minimum: 100 KB
Default
The default length is 20000 KB.
Considerations
• Once a current audit file reaches the maximum size, a log rollover will occur. The current file will be closed and
a new file will be opened. The new file will be named based on the audit round robin file set specified by the
AUDITFILE and AUDITRETENTION parameters. If the file name already exists, any existing contents will be
purged.
See also:
• AUDITCONSOLE, AUDITFILE, AUDITFILERETENTION
• "Audit Messages" in the chapter titled "Monitoring and Auditing"
AUTOADDSYSTEMUSERS
Use this parameter to control whether remote users can log on via SSH using a Guardian user ID or alias, without
configuring them explicitly via SSHCOM in the SSHCTL.

HP NonStop SSH 544701-014 Specifications

General

Brand	HP
Model	NonStop SSH 544701-014
Category	Software
Language	English