HP NonStop SSH 544701-014

HP NonStop SSH Reference Manual Configuring and Running SSH2 • 85
Bit 5 (decimal 16) Process ID (name or PIN)
Bit 7 (decimal 64) Log level of message
Default
The default log format is 93 (date, time, milliseconds, process ID, and log level).
Example
Display date, time, and milliseconds only:
LOGFORMATCONSOLE 13
Display date and time only:
LOGFORMATCONSOLE 5
See also:
LOGFORMATFILE, LOGFORMATEMS
LOGFORMATEMS
Use this parameter to control the format of the log messages that are written to EMS.
Parameter Syntax
LOGFORMATEMS format
Arguments
format
A number is used to represent a bit mask that controls the format. Following are the values and their
corresponding format:
bit 1 (decimal 1) Date
bit 2 (decimal 2) Header (log messages a pre-fixed with "[log]")
bit 3 (decimal 4) Time
bit 4 (decimal 8) Milliseconds
bit 5 (decimal 16) Process ID (name or PIN)
bit 7 (decimal 64) Log level of message
Default
The default log format is 93 (date, time, milliseconds, process ID, and log level).
Example
Display date, time, and milliseconds only:
LOGFORMATEMS 13
Display date and time only:
LOGFORMATEMS 5
See also:
LOGFORMATCONSOLE, LOGFORMATFILE