HP NonStop SSH 544701-014

142 • SSHCOM Command Reference HP NonStop SSH Reference Manual
[def ] STOREDPASSWORDSONLY <FALSE>
[def ] STRICTHOSTKEYCHECKING <TRUE>
[def ] SUBNET <$ZTC0>
[def ] SUPPRESSCOMMENTINSSHVERSION <FALSE>
[def ] TCPIPHOSTFILE <*>
[def ] TCPIPNODEFILE <*>
[def ] TCPIPRESOLVERNAME <*>
-----------------------------------------------------------
Current configuration:
LOGCONSOLE %
LOGEMS *
LOGFILE *
LOGFORMATCONSOLE 93
LOGFORMATEMS 16
LOGFORMATFILE 93
LOGLEVELCONSOLE 50
LOGLEVELEMS 20
LOGLEVELFILE 50
LOGMAXFILELENGTH 20000
LOGFILERETENTION 10
LOGMEMORYDETAILED 0
LOGCACHESIZE 1024 (current number of messages in cache: 0)
LOGLEVELCACHE 0
LOGCACHEDUMPONABORT 1
AUDITCONSOLE *
AUDITEMS *
AUDITFILE *
AUDITFORMATCONSOLE 0
AUDITFORMATEMS 0
AUDITFORMATFILE 21
AUDITMAXFILELENGTH 20000
AUDITFILERETENTION 10
%
CLEAR LOGCACHE
If a log cache is written (see parameters LOGLEVELCACHE, LOGCACHESIZE), the command CLEAR LOGCACHE
can be used to clear the cache. It has the following syntax:
CLEAR LOGCACHE
The original content of the log cache is lost when executing this command.
FLUSH LOGCACHE
If a log cache is written (see parameters LOGLEVELCACHE, LOGCACHESIZE), the command FLUSH LOGCACHE
can be used to write the content of the log cache to the configured log file (parameter LOGFILE must not be set to a
value of * to be able to flush the log cache). It has the following syntax:
FLUSH LOGCACHE
The log cache will be automatically cleared after the content of the log cache was written to the current log file.
INFO DEFINE
The INFO DEFINE command displays information about the DEFINEs as they exist in the SSH2 process context. It has
the following syntax: