74 • Configuring and Running SSH2 HP NonStop SSH Reference Manual
• Both values for INTERFACE and INTERFACEOUT must exist in the same TCP/IP process configured via
parameter SUBNET or define =TCPIP^PROCESS^NAME
See also:
SUBNET, INTERFACEOUT, IPMODE
INTERFACEOUT
Use this parameter to specify the local IP address SSH2 should bind to for outgoing SSH connections.
Parameter Syntax
INTERFACEOUT <ip-address>
Arguments
<ip-address>
Specifies the local IP address SSH2 binds the TCP/IP socket to before connecting to a remote system..
Default
If omitted, SSH2 will bind to the IP address configured via parameter INTERFACE. If neither parameter
INTERFACEOUT nor INTERFACE is set (or configured with value 0.0.0.0 / 0::0), any local IP addresses of the
configured TCPIP process (SUBNET) will be used, selected by the TCPIP process.
Considerations
• The value must be set consistent with the value of parameter IPMODE.
• If IPMODE parameter is set to DUAL, then an IPv6 address must be used (IPv4-mapped IPv6 address for IPv4
addresses)
• Both values for INTERFACE and INTERFACEOUT must exist in the same TCP/IP process configured via
parameter SUBNET or define =TCPIP^PROCESS^NAME
Example
INTERFACEOUT 10.0.0.197
See also:
INTERFACE, SUBNET, IPMODE
INTERVALLIVEPRIVATEUSERKEY
This parameter is related to a user private key’s life-cycle (configuration of database entity KEY). It determines the
length of the interval a user private key stays in state ‘LIVE’.
Parameter Syntax
INTERVALLIVEPRIVATEUSERKEY number-of-days
Arguments
number-of-days
The number of days a newly generated user private key will be in state ‘LIVE’ after leaving state ’PENDING’
and before reaching state ‘EXPIRED’.
Default
The default value for this parameter is 730, i.e. 2 years.
To Next Page
Loading...
