HP NonStop SSH 544701-014

HP NonStop SSH Reference Manual Configuring and Running SSH2 • 105
Arguments
time
A number representing the maximum time for TCP retransmission timeout. A value of 0 means the maximum
continuous time spent retransmitting without receiving an acknowledgement from the other endpoint configured
in the TCP/IP monitor process is used.
Considerations
• Normally the value configured on TCP/IP monitor process level should be sufficient, i.e. the default value
should be used for parameter SOCKTCPTOTRXMTVAL. See document "HP NonStop TCP/IPv6
Configuration and Management Manual" for details.
• The Cluster I/O Protocols (CIP) subsystem does not support the corresponding socket option
TCP_TOTRXMTVAL, i.e. the default value must be used for parameter SOCKTCPTOTRXMTVAL if CIP is
involved. See document "HP NonStop TCP/IPv6 Configuration and Management Manual" for details.
Default
The default is 0.
SSHAUTOKEXBYTES
Use this parameter to control the frequency of automatic key re-exchange in SSH sessions.
Parameter Syntax
SSHAUTOKEXBYTES bytes
Arguments
bytes
Provides a number representing the amount of bytes after which a key re-exchange should be initiated. A value
of 0 disables key re-exchange based on data volume.
Default
The default is 1073741824 (1GB). This is the value recommended in RFC 4253.
See also:
SSHAUTOKEXTIME
SSHAUTOKEXTIME
Use this parameter to control the frequency of automatic key re-exchange in SSH sessions.
Parameter Syntax
SSHAUTOKEXTIME seconds
Arguments
seconds
Specifies the intervals between key re-exchanges in seconds. A value of 0 disables key re-exchange based on
time intervals.
Default
The default is 3600 (1 hour). This is the value recommended in RFC 4253.
See also: