HP NonStop SSH Reference Manual SSHCOM Command Reference • 139
• A guardian user can display, add, and manipulate entries for the Guardian user.
• Depending on the rules explained in the section about OBJECTTYPE USER records a group manager can add,
change or delete client mode records stored under a Guardian name.
• A user with full access can add/manipulate all entries unless an OBJECTTYPE USER record says otherwise.
Miscellaneous commands in SSHCOM
The following commands are independent of the mode set with the mode command:
MODE
As described earlier, the MODE command will work in both run modes of SSHCOM. If entered without specifying a
mode, the command will show the current mode under which SSHCOM is operating:
$DATA1 TBSSH 29> run sshcom $tba00
T9000B03_02DEC2009_SSHCOM
OPEN $tba00
% mode
Mode
current mode is CLIENT
%
The command has the following syntax:
MODE [CLIENT | DAEMON | SERVER]
The individual attributes have the following meaning and syntax:
CLIENT
Switches to CLIENT mode.
DAEMON
Switches to DAEMON mode.
SERVER
SERVER is a synonym for DAEMON and therefore switches to DAEMON mode as well.
SET
The SET command allows you to change some configuration parameters during runtime. Currently the following
parameters are supported:
Parameter Meaning
AUDITCONSOLE Determines whether audit messages are written to the console.
AUDITEMS Determines whether audit messages are written to EMS.
AUDITFILE Determines whether audit messages are written to a file.
AUDITFORMATCONSOLE Controls the format of the audit messages that are written to the console.
AUDITFORMATEMS Controls the format of the audit messages that are written to EMS.
AUDITFORMATFILE Controls the format of the audit messages that are written to a file.
LOGCACHEDUMPONABORT Determines if the internal log cache is written to the log file in case of process aborting.
LOGCACHESIZE Determines the size of the internal log cache.
LOGCONSOLE Determines whether log messages are written to a console.
LOGEMS Determines whether log messages are written to EMS.
To Next Page
Loading...
Need help?
General