HP NonStop SSH Reference Manual STN Reference • 247
The output has the following format:
SERVICE <name> <status>, Cumulative sessions=<a>
, WINDOWs: Configured=<b>, In session=<c>, Open&ready=<d>
<status>
STARTED or STOPPED.
<a>
Total number of sessions ever connected to this service.
<b>
Number of windows presently configured for this service.
<c>
Number of currently open sessions for this service.
<d>
For static services, the number of windows with application opens, ready for new sessions.
STATUS SESSION [ <session-name> | * ]
STATUS SESSION shows all active sessions, even those that have not yet been attached to a window. The output format
for sessions created via SSH is as follows:
SESSION <window> SSH <ipaddr-port> <state>
<window>
The window name associated with this session. During session startup, this can refer to a dynamic window that has not
yet been created. For static windows, this name will be changed to the static window name.
<ipaddr-port>
IP address and port number of the remote client.
<state>
Tracks the progress of a new session.
• NEGOT
Telnet IAC negotiations are in process with an SSH 6530 client.
• NEGOT_LM
For TN6530 sessions, line mode has been established, and the STN is waiting for TERMTYPE. This state
usually lasts for less than a second.
• NEGOT_TT
For TN6530 sessions, TERMTYPE has been established, and the STN is waiting for line mode. This state
usually lasts for less than a second.
• MENU_NEEDED
TERMTYPE has been established, and, for TN6530, line mode has been established. This state is usually
immediately replaced by MENU.
• RESIL_RECON
A resilient window has been reconnected to a new session. This state is usually immediately replaced by
CONNECTED.
• MENU
STN is waiting for a service name (or window name) from the remote SSH 6530 client, usually after displaying
a menu of service names.
To Next Page
Loading...
