HP NonStop SSH Reference Manual STN Reference • 277
207
P1 and P2 are ignored; ascii "ST" and "N0" are returned as last parameters. This can be used by applications to verify
that the file is really an STN process. Telserv will never respond with this string.
208
P1=1 (default) When a Posix read is active, signal characters (like control-C) generate Guardian Break when break is
enabled. P1=0 generates the Posix signal.
212
To control setting of Pending^140 flag on session termination. Default is 1 which sets Pending^140 on session
termination. 212,0 means Pending^140 flag is never set. Pending^140 controls the response to application I/O requests
when no session is active.
Pending^140 set: Control 11 clears pending^140 and waits for a new session. Control 12 is ignored. All other requests
are rejected with FESESSDOWN.
Pending^140 clear : Setmodes are handled normally, but any changes may be re-initialized when a new session starts.
All other requests are handled the same as above for Pending^140 set.
214
Used to override results of deviceinfo (and related calls) against a window. Open a window and use setmode 214 with
both P1 and P2 specified. If P1 is nonzero, then it overrides the device type and device subtype returned by deviceinfo.
The device type is taken from P1.<4:9> and the subtype from P1.<10:15>. If P2 is nonzero, then it overrides the record
length returned by deviceinfo. No range checking is done on either parameter. Setmode 214 P1 and P2 both default to
zero when a window is added, and the value is not changed or reset by session termination or startup (unless part of a
SCRIPT).
Setmode 214 may be used with ADD SCRIPT, but with a static window the script will not be applied until the first
session connects.
Standard SETPARAM Functions:
37 break handling
Extended SETPARAM Functions (unique to STN):
200 returns STN vproc information, example: Gemini STN A50 22JUN2006
201 returns the IP address of the remote workstation as reported by NonStop TCP/IP call accept_nw (4 bytes)
202 returns the WSINFO host name or empty string
203 returns the WSINFO ip address or empty string
204 returns the WSINFO user name or empty string
205 returns the IP port number of the remote workstation as reported by NonStop TCP/IP call accept_nw (2 bytes)
206 returns the IP address of the NonStop host as reported by NonStop TCP/IP call getsockname (4 bytes)
207 returns the IP port of the NonStop host as reported by NonStop TCP/IP call getsockname (2 bytes)
208 returns the Kerberos Principal Name if available for PTY sessions.
209 Info from WSINFO domain or empty string.
210 Info from WSINFO netbios or empty string.
211 Info from WSINFO client or empty string
To Next Page
Loading...
Need help?
General