Using Windows 98
Installing Retail Windows 98 Second Edition or Windows 98
Corporate Evaluator’s Guide 131
To install infrared support
If you have installed retail Windows and have IR devices to use with your computer, you
need to install the IR driver. The driver is contained in the \HP\DRIVERS\FIR
subdirectory on the Recovery CD.
Note
If you have the infrared enabled in the BIOS prior to the installation of Windows 98, the
operating system will discover the IR hardware automatically.
To install or upgrade the infrared driver:
1. Run SETUP.EXE from the driver directory on your Recovery CD
(\HP\DRIVERS\FIR\QUIKBEAM).
2. Follow the onscreen directions to complete installation.
3. You may see a message saying that you already have IR drivers installed by
Windows. Select YES to replace the Windows driver with the QuickBeam IR driver.
4. Another message box will appear asking what serial port the IR is operating on.
Select GENERIC IR SERIAL PORT and click Next.
Upon successful completion you will be asked to reboot your computer, choose “No, I
will restart my computer later.” and continue to next step.
To install Bay Manager support
If you have installed retail Windows you will need to install the bay manager software so
you will be able to hot swap modules from the system. The driver is contained in the
\HP\DRIVERS\BAYMGR subdirectory on the Recovery CD.
To install or upgrade the bay manager driver:
1. Run SETUP.EXE from the driver directory on your Recovery CD
(\HP\DRIVERS\BAYMGR).
2. Follow the onscreen directions to complete installation.
Upon successful completion you will be asked to reboot your computer, choose “No, I
will restart my computer later.” and continue to next step.
To Next Page
Loading...
