Batteries and Power Management 
Using Battery Power 
54  Corporate Evaluator’s Guide 
To respond to a low-battery warning 
The computer automatically alerts you when the battery power drops to a critically low 
level. The computer first emits a high-pitched beep or displays a warning message. Then, 
if you do not restore power within a short time, the computer goes into Hibernate mode. 
Once the computer enters Hibernate mode in this way, you won’t be able to turn it on 
again until you restore power by doing one of the following: 
•  Replace the battery with a charged one. See “Step 1: Install the battery” on page 22. 
•  Plug in the AC adapter. See “Step 2: Connect AC power” on page 24. 
•  Install a charged secondary battery in the plug-in module bay. See “To use additional 
batteries” on page 54. 
Note 
If you plug in the AC adapter, you can continue to work while your battery recharges. 
To recharge the battery 
CAUTION 
The AC adapter is normally warm whenever plugged into an AC outlet. The 
computer is normally warm while recharging. Don’t recharge the computer in a 
briefcase or other confined space, or its battery could overheat. 
•  To recharge the main battery, plug the AC adapter into the computer.  
•  To recharge a secondary battery, plug the AC adapter into the computer and insert the 
battery into the module bay. 
The main battery will recharge first, then the secondary battery will recharge. 
To get the longest operating time, wait until the battery’s charge is below 50% before 
recharging, then charge it fully (100%). Charging can take up to approximately 2 hours. 
You can continue working while the battery charges. 
A fully charged battery can operate the computer for up to approximately 4–5 hours, 
depending on your computer’s model, power management settings, and level of use. 
To use additional batteries 
You can install a secondary battery in your computer’s plug-in module bay. See “Using 
Plug-In Modules” on page 74 for information about installing plug-in modules. For 
instructions on replacing the main battery, see “Step 1: Install the battery” on page 22.