Using Windows NT 4.0
Installing Retail Windows NT 4.0
Corporate Evaluator’s Guide 145
To install video support (ATI Mobility Radeon)
If you have installed retail Windows you need to install the video driver. The driver is
contained in the \HP\DRIVERS\VIDEO subdirectory on the Recovery CD.
Note
You must have NT Service Pack 4 or higher installed prior to this step.
To install or upgrade the video driver:
1. Run SETUP.EXE from the driver directory on your Recovery CD
(\HP\DRIVERS\VIDEO).
2. Follow the onscreen directions to complete installation.
Upon successful completion you will be asked to reboot your computer, choose YES if
you have no other drivers to install. Otherwise, choose NO and continue to next step.
Note
Depending on the system you have purchased your native resolution will be 1024x768
with 65536 colors or 1400x1050 with 65536 colors. These are the resolutions your
system should be run at for optimal full-screen performance.
The driver will be installed after the system reboots. Upon successful installation, an ATI
icon appears on the bottom right corner of the taskbar.
To install networking support
If you have installed retail Windows you need to install the networking support. This
section assumes that no networking has been installed on the system.
To install or upgrade the networking driver:
1. Plug your network cable into the HP notebook.
2. Copy the entire contents of the directory D:\HP\DRIVERS\LAN from the Recovery
CD to the directory C:\LAN.
3. Right-click Network Neighborhood and choose Properties. If you have no
networking installed the system will ask you if you want to install networking now.
Click YES.
4. Choose Wired to Network, click Next.
5. Click Select From List.
6. Click Have Disk.
7. In the dialog box enter C:\LAN
8. Pick Intel Pro/100 Mobile Adapter from the list, click OK.
To Next Page
Loading...
