To Next Page

To Previous Page

Interface Access and System Information

Overview

This chapter describes how to:

■ View and modify the configuration for switch interface access

■ Use the CLI kill command to terminate a remote session

■ View and modify switch system information

For help on how to actually use the interfaces built into the switch, refer to:

■ Chapter 2, “Using the Menu Interface”

■ Chapter 4, “Using the Command Line Interface (CLI)”

■ Chapter 5, “Using the Web Browser Interface”

Why Configure Interface Access and System Information? The inter-

face access features in the switch operate properly by default. However, you

can modify or disable access features to suit your particular needs. Similarly,

you can choose to leave the system information parameters at their default

settings. However, modifying these parameters can help you to more easily

distinguish one device from another in your network.

7-2

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General