To Next Page

To Previous Page

Monitoring and Analyzing Switch Operation

Status and Counters Data

Internet Group Management Protocol (IGMP) Status

The switch uses the CLI to display the following IGMP status on a per-VLAN

basis:

Show Command Output

show ip igmp Global command listing IGMP status for all VLANs configured

in the switch:

• VLAN ID (VID) and name

• Active group addresses per VLAN

• Number of report and query packets per group

• Querier access port per VLAN

show ip igmp <vlan-id> Per-VLAN command listing above IGMP status for specified

VLAN (VID)

show ip igmp group <ip-addr> Lists the ports currently participating in the specified group,

with port type, Access type, Age Timer data and Leave Timer

data.

For example, suppose that show ip igmp listed an IGMP group address of

224.0.1.22. You could get additional data on that group by executing the

following:

Figure B-14. Example of IGMP Group Data

B-19

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General