HP ProCurve 2810 Series User Manual

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Displaying Switch Information Available for Outbound
Advertisements
These commands display the current switch information that will be used to
populate outbound LLDP advertisements.
Syntax show lldp info local-device [ port-list ]
Without the [ port-list ] option, this command displays the global
switch information and the per-port information currently
available for populating outbound LLDP advertisements.
With the [ port-list ] option, this command displays only the
following port-specific information that is currently available
for outbound LLDP advertisements on the specified ports:
• PortType
• PortId
• PortDesc
Note: This command displays the information available on
the switch. Use the lldp config < port-list > command to change
the selection of information that is included in actual
outbound advertisements. In the default LLDP configuration,
all information displayed by this command is transmitted in
outbound advertisements.
For example, in the default configuration, the switch information currently
available for outbound LLDP advertisements appears similar to the display in
figure 12-13 on page page 12-44.
12-43

HP ProCurve 2810 Series Specifications

General

Jumbo Frame Support	Yes
Model	HP ProCurve 2810 Series
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 SFP (mini-GBIC) slots
Forwarding Rate	71.4 Mpps
Layer	Layer 2
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static IP routing
Form Factor	Rack-mountable
Power Consumption	48W (24-port)
Operating Temperature	32°F to 0°F (0°C to 0°C)
Operating Humidity	15% to 95% non-condensing
Power Supply	Internal power supply