To Next Page

To Previous Page

Configuring IP Addressing

Overview

You can configure IP addressing through all of the switch’s interfaces. You can

also:

■ Easily edit a switch configuration file to allow downloading the file to

multiple switches without overwriting each switch’s unique gateway and

VLAN 1 IP addressing.

■ Assign up to seven secondary IP addresses to a VLAN (multinetting)

Why Configure IP Addressing? In its factory default configuration, the

switch operates as a multiport learning bridge with network connectivity

provided by the ports on the switch. However, to enable specific management

access and control through your network, you will need IP addressing. Table

8-1 on page 8-12 shows the switch features that depend on IP addressing to

operate.

8-2

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General