To Next Page

To Previous Page

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

SNMPv3 Enable

The snmpv3 enable command starts a dialog that performs three functions:

enabling the switch to receive SNMPv3 messages, configuring the initial users,

and, optionally, to restrict non version-3 messages to “read only”. Figure 12-1

shows and example of this dialog.

Not e :

SNMP

V e rsion 3

Ini tia l User s

For most SNMPv3 management software to be able to create new users, they

must have an initial user record clone. These records can be downgraded,

(given fewer features), but not upgraded with new features added. For this

reason ProCurve recommends that you create a second user with SHA and

DES at when you enable SNMPv3

Enable

Create initial user models for SNMPv3

management applications.

Set restriction on

non-SNMPv3 messages.

Figure 12-1. Example of SNMP version 3 Enable Command

12-7

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General