To Next Page

To Previous Page

Using the Web Browser Interface

Starting a Web Browser Interface Session with the Switch

Using ProCurve Manager (PCM) or ProCurve Manager

Plus (PCM+)

ProCurve Manager and ProCurve Manager Plus are designed for installation

on a network management workstation. For this reason, the system require-

ments are different from the system requirements for accessing the switch’s

web browser interface from a non-management PC or workstation. For

ProCurve PCM and PCM+ requirements, refer to the information provided

with the software.

This procedure assumes that:

■ You have installed the recommended web browser on a PC or workstation

that serves as your network management station.

■ The networked device you want to access has been assigned an IP address

and (optionally) a DNS name, and has been discovered by PCM or PCM+.

(For more on assigning an IP address, refer to “IP Configuration” on page

8-3.)

To establish a web browser session with ProCurve PCM or PCM+ running, do

the following on the network management station:

1. Make sure the Java

applets are enabled for your web browser. If they

are not, refer to the web browser online Help for specific information on

enabling the Java applets.

2. In the Interconnected Devices listing under Network Manager Home (in the

PCM/PCM+ sidebar), right-click on the model number of the device you

want to access.

3. The web browser interface automatically starts with the Status Overview

window displayed for the selected device, as shown in figure 5-1.

Note If the Registration window appears, click on the Status tab.

5-5

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General