To Next Page

To Previous Page

File Transfers

Downloading Switch Software

Running Total

of Bytes

Downloaded

Figure A-5. Switch-To-Switch, from Primary in Source to Either Flash in

Destination

Downloading from Either Flash in the Source Switch to Either Flash

in the Destination Switch. This command (executed in the destination

switch) gives you the most options for downloading between switches.

Syntax: copy tftp flash < ip-addr > < /os/primary > | < /os/secondary >

[primary | secondary]

If you do not specify either a primary or secondary flash location for the

destination, the download automatically goes to primary flash.

For example, to download switch software from secondary flash in a switch

with an IP address of 10.28.227.103 to the secondary flash in the destination

switch, you would execute the following command in the destination switch’s

CLI:

Figure A-6. Switch-to-Switch, from Either Flash in Source to Either Flash in

Destination

Using ProCurve Manager Plus to Update Switch

Software

ProCurve Manager Plus include a software update utility for updating on

ProCurve switch products. For further information, refer to the Getting

Started Guide and the Administrator’s Guide, provided electronically with

the application.

A-16

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General