Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
system_cap
For outbound advertisements, this TLV includes a
bitmask of supported system capabilities (device
functions). Also includes information on whether the
capabilities are enabled.
(Default: Enabled)
For example, if you wanted to exclude the system name TLV from the
outbound LLDP advertisements for all ports on a switch, you would use this
command:
ProCurve(config)# no lldp config 1-24 basicTlvEnable
system_name
If you later decided to reinstate the system name TLV on ports 1-5, you would
use this command:
ProCurve(config)# lldp config 1-5 basicTlvEnable
system_name
Displaying Advertisement Data
Command Page
show lldp info local-device below
show lldp info remote-device 12-44
show lldp info stats 12-47
12-42
To Next Page
Loading...
