To Next Page

To Previous Page

Port Status and Basic Configuration

Jumbo Packets

traffic from devices on either VLAN. For a method to allow only some

ports in a VLAN to receive jumbo traffic, refer to “Operating Notes for

Jumbo Traffic-Handling” on page 10-20.

Configuring Jumbo Packet Operation

Command Page

show vlans 10-18

show vlans ports < port-list > 10-19

show vlans < vid > 10-20

jumbo 10-20

Overview

1. Determine the VLAN membership of the ports or trunks through which

you want the switch to accept inbound jumbo traffic. For operation with

GVRP enabled, refer to the GVRP topic under “Operating Rules”, above.

2. Ensure that the ports through which you want the switch to receive jumbo

packets are operating at least at gigabit speed. (Check the Mode field in

the output for the show interfaces brief < port-list > command.)

3. Use the jumbo command to enable jumbo packets on one or more VLANs

statically configured in the switch. (All ports belonging to a jumbo-

enabled VLAN can receive jumbo packets.

4. Execute write memory to save your configuration changes to the startup-

config file.

10-17

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General