To Next Page

To Previous Page

Using the Web Browser Interface

Overview

The Web browser interface built into the switch lets you easily access the

switch from a browser-based PC on your network. This lets you do the

following:

■ Optimize your network uptime by using the Alert Log and other diagnostic

tools

■ Make configuration changes to the switch

■ Maintain security by configuring usernames and passwords

This chapter covers the following:

■ General features (page 5-3).

■ Starting a web browser interface session (page 5-4)

■ Tasks for your first web browser interface session (page 5-7):

• Creating usernames and passwords in the web browser interface

(page 5-8)

• Selecting the fault detection configuration for the Alert Log operation

(page 5-23)

• Getting access to online help for the web browser interface (page

5-11)

■ Description of the web browser interface:

• Overview window and tabs (page 5-16)

• Port Utilization and Status displays (page 5-17)

• Alert Log and Alert types (page 5-20)

• Setting the Fault Detection Policy (page 5-23)

Note If you want security beyond that achieved with user names and passwords,

you can disable access to the web browser interface. This is done by either

executing no web-management at the Command Prompt or changing the Web

Agent Enabled parameter setting to No (page 7-3).

5-2

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General