To Next Page

To Previous Page

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

Group Access Levels

The switch supports eight predefined group access levels. There are four

levels for use with version 3 users and four are used for access by version 2c

or version 1 management applications.

Group Name Group Access Type Group Read View Group Write View

managerpriv Ver3 Must have Authentication ManagerReadView ManagerWriteView

and Privacy

managerauth Ver3 Must have Authentication ManagerReadView ManagerWriteView

operatorauth Ver3 Must have Authentication OperatorReadView DiscoveryView

operatornoauth Ver3 No Authentication OperatorReadView DiscoveryView

commanagerrw Ver2c or Ver1 ManagerReadView ManagerWriteView

commanagerr Ver2c or Ver1 ManagerReadView DiscoveryView

comoperatorrw Ver2c or Ver1 OperatorReadView OperatorReadView

comoperatorr Ver2c or Ver1 OperatorReadView DiscoveryView

Each view allows you to view or modify a different set of MIBs.

■ Manager Read View – access to all managed objects

■ Manager Write View – access to all managed objects except the follow-

ing: vacmContextTable, vacmAccessTable, vacmViewTreeFamilyTable

■ OperatorReadView – no access to icfSecurityMIB, ProCurveIpTftp-

Mode, vacmContextTable, vacmAccessTable, vacmViewTreeFami-

lyTable, usmUserTable, snmpCommunityTable

■ Discovery View – Access limited to samplingProbe MIB.

Note All access groups and views are predefined on the switch. There is no method

to modify or add groups or views to those that are pre-defined on the switch.

12-11

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General