To Next Page

To Previous Page

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

Then you must set the group access level to the user. This is done with the

snmpv3 group command. For more details on the MIBs access for a give group

see “Group Access Levels” on page 12-11.

Add NetworkAdmin to

operator noauth group

Add NetwrokMgr to managerpriv group

Pre-assigned groups for

access by Version 2c and

version 1 management

applications

Figure 12-3. Assign Users to group for SNMPv3

Caution Adding a user without authentication and/or privacy to a group that requires

it will cause the user to not be able to access the switch. You should only add

users to the group that is appropriate for their security parameters

12-10

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General