To Next Page

To Previous Page

Time Protocols

SNTP: Viewing, Selecting, and Configuring

Time Protocol Selection Parameter

–TIMEP

–SNTP

– None

Figure 9-1. The System Information Screen (Default Values)

2. Press

[E] (for Edit). The cursor moves to the System Name field.

3. Use [v] to move the cursor to the Time Sync Method field.

4. Use the Space bar to select SNTP, then press [v] once to display and move

to the SNTP Mode field.

5. Do one of the following:

• Use the Space bar to select the Broadcast mode, then press [v] to

move the cursor to the Poll Interval field, and go to step 6. (For

Broadcast mode details, see “SNTP Operating Modes” on

page 9-2.)

• Use the Space bar to select the

Unicast mode, then do the

following:

i. Press [>] to move the cursor to the Server Address field.

9-6

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General