To Next Page

To Previous Page

Time Protocols

SNTP: Viewing, Selecting, and Configuring

Note Deleting an SNTP server when only one is configured disables SNTP unicast

operation.

For example, to select SNTP and configure it with unicast mode and an SNTP

server at 10.28.227.141 with the default server version (3) and default poll

interval (720 seconds):

ProCurve(config)# timesync sntp

Selects SNTP.

ProCurve(config)# sntp unicast

Activates SNTP in Unicast mode.

ProCurve(config)# sntp server 10.28.227.141

Specifies the SNTP server and accepts the current SNTP server

version (default: 3).

In this example, the Poll Interval and the Protocol

Version appear at their default settings.

Note: Protocol Version appears only when there is an

IP address configured for an SNTP server.

Figure 9-5. Example of Configuring SNTP for Unicast Operation

If the SNTP server you specify uses SNTP version 4 or later, use the sntp server

command to specify the correct version number. For example, suppose you

learned that SNTP version 4 was in use on the server you specified above (IP

address 10.28.227.141). You would use the following commands to delete the

server IP address and then re-enter it with the correct version number for that

server:

9-11

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General