To Next Page

To Previous Page

Time Protocols

TimeP: Viewing, Selecting, and Configuring

Figure 9-13. Example of Configuring Timep for Manual Operation

Changing the TimeP Poll Interval. This command lets you specify how

long the switch waits between time polling intervals. The default is 720

minutes and the range is 1 to 9999 minutes. (This parameter is separate from

the poll interval parameter used for SNTP operation.)

Syntax: ip timep dhcp interval < 1 . . 9999 >

ip timep manual interval < 1 . . 9999 >

For example, to change the poll interval to 60 minutes:

ProCurve(config)# ip timep interval 60

Disabling Time Synchronization Without Changing the TimeP

Configuration. The recommended method for disabling time synchroniza-

tion is to use the timesync command. This halts time synchronization without

changing your TimeP configuration.

Syntax: no timesync

For example, suppose TimeP is running as the switch’s time synchronization

protocol, with

DHCP as the TimeP mode, and the factory-default polling

interval. You would halt time synchronization with this command:

ProCurve(config)# no timesync

If you then viewed the TimeP configuration, you would see the following:

Figure 9-14. Example of TimeP with Time Sychronization Disabled

9-20

Other manuals for HP ProCurve 2810 Series

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2810 Series and is the answer not in the manual?

General