HP ProCurve 2810 Series User Manual

Port Status and Basic Configuration
Using Friendly (Optional) Port Names
Configuring the Same Name for Multiple Ports. Suppose that you want
to use ports A5 through A8 as a trunked link to a server used by a drafting
group. In this case you might configure ports A5 through A8 with the name
“Draft-Server:Trunk”.
Figure 10-17. Example of Configuring One Friendly Port Name on Multiple
Ports
10-33

HP ProCurve 2810 Series Specifications

General

Jumbo Frame Support	Yes
Model	HP ProCurve 2810 Series
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 SFP (mini-GBIC) slots
Forwarding Rate	71.4 Mpps
Layer	Layer 2
Management	Web, SNMP, CLI
MAC Address Table Size	16000 entries
Routing Protocol	Static IP routing
Form Factor	Rack-mountable
Power Consumption	48W (24-port)
Operating Temperature	32°F to 0°F (0°C to 0°C)
Operating Humidity	15% to 95% non-condensing
Power Supply	Internal power supply