HP ProCurve Switch 2650 User Manual

3-4
RADIUS Authentication and Accounting
Switch Operating Rules for RADIUS
Switch Operating Rules for RADIUS
 You must have at least one RADIUS server accessible to the switch.
 The switch supports authentication and accounting using up to three
RADIUS servers. The switch accesses the servers in the order in
which they are listed by show radius ( page 3-23). If the first server
does not respond, the switch tries the next one, and so-on. (To change
the order in which the switch accesses RADIUS servers, refer to
“Changing RADIUS-Server Access Order” on page 3-27.)
 You can select RADIUS as the primary authentication method for each
type of access. (Only one primary and one secondary access method
is allowed for each access type.)
 In the HP switch, EAP RADIUS uses MD5 and TLS to encrypt a
response to a challenge from a RADIUS server.
!FishSecurity.book Page 4 Thursday, October 10, 2002 9:19 PM

HP ProCurve Switch 2650 Specifications

General

Switching Capacity	13.6 Gbps
Forwarding Rate	10.1 Mpps
Layer	Layer 2
Form Factor	Rack-mountable
Flash Memory	8 MB
Jumbo Frame Support	Yes
Power Supply	Internal
Management	Web, CLI, SNMP
Features	VLAN support, IGMP snooping, QoS
Operating Temperature	0°C to 45°C (32°F to 113°F)
Operating Humidity	15% to 95% (non-condensing)
Ports	48 x 10/100
MAC Address Table Size	8, 000 entries