2-9
TACACS+ Authentication
Configuring TACACS+ on the Switch
Configuring TACACS+ on the Switch
Before You Begin
If you are new to TACACS+ authentication, HP recommends that you read the
“General Authentication Setup Procedure” on page 2-6 and configure your
TACACS+ server(s) before configuring authentication on the switch.
The switch offers three command areas for TACACS+ operation:
show authentication and show tacacs: Displays the switch’s TACACS+
configuration and status.
aaa authentication: A command for configuring the switch’s authenti-
cation methods
tacacs-server: A command for configuring the switch’s contact with
TACACS+ servers
CLI Commands Described in this Section
Command Page
show authentication 2-10
show tacacs 2-10
aaa authentication pages 2-11 through 2-14
console
Telnet
num-attempts <1..10 >
tacacs-server pages 2-15
host < ip-addr > pages 2-15
key 2-19
timeout < 1 ..255 > 2-20
!FishSecurity.book Page 9 Thursday, October 10, 2002 9:19 PM
To Next Page
Loading...
