7-6
Using Authorized IP Managers
Defining Authorized Management Stations
Figure 7-2. Example of How To Add an Authorized Manager Entry (Continued)
Editing or Deleting an Authorized Manager Entry. Go to the IP Manag-
ers List screen (figure 7-1), highlight the desired entry, and press
(for Edit)
or
(for Delete).
CLI: Viewing and Configuring Authorized IP Managers
Authorized IP Managers Commands Used in This Section
Listing the Switch’s Current Authorized IP Manager(s)
Use the show ip authorized-managers command to list IP stations authorized to
access the switch. For example:
Figure 7-3. Example of the Show IP Authorized-Manager Display
5. Press
, then
(for Save) to configure the IP
Authorized Manager entry.
3. Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
“Building IP Masks”on page 7-9.
2. Enter an Authorized Manager IP address here.
4. Use the Space bar to select Manager or Operator
access.
Command Page
show ip authorized-managers below
ip authorized-managers 7-7
<ip-address> 7-8
mask <mask-bits> 7-8
<operator | manager>
!FishSecurity.book Page 6 Thursday, October 10, 2002 9:19 PM
To Next Page
Loading...
