HP ProCurve Switch 2650 User Manual

3-14
RADIUS Authentication and Accounting
Local Authentication Process
Figure 3-6. Listings of Global RADIUS Parameters Configured In Figure 3-5
Local Authentication Process
When the switch is configured to use RADIUS, it reverts to local authentication
only if one of these two conditions exists:
 "Local" is the authentication option for the access method being used.
 The switch has been configured to query one or more RADIUS servers
for a primary authentication request, but has not received a response,
and local is the configured secondary option.
After two attempts failing due
to username or password
entry errors, the switch will
terminate the session.
Global RADIUS parameters
from figure 3-5.
These two servers will use the
global encryption key.
Server-specific encryption key
for the RADIUS server that will
not use the global encryption
key.
!FishSecurity.book Page 14 Thursday, October 10, 2002 9:19 PM

HP ProCurve Switch 2650 Specifications

General

Switching Capacity	13.6 Gbps
Forwarding Rate	10.1 Mpps
Layer	Layer 2
Form Factor	Rack-mountable
Flash Memory	8 MB
Jumbo Frame Support	Yes
Power Supply	Internal
Management	Web, CLI, SNMP
Features	VLAN support, IGMP snooping, QoS
Operating Temperature	0°C to 45°C (32°F to 113°F)
Operating Humidity	15% to 95% (non-condensing)
Ports	48 x 10/100
MAC Address Table Size	8, 000 entries