EasyManuals Logo

HP ProCurve Switch 2650 User Manual

HP ProCurve Switch 2650
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
1-5
Configuring Username and Password Security
Configuring Local Password Security
If you have physical access to the switch, press and hold the Clear button (on
the front of the switch) for a minimum of one second to clear all password
protection, then enter new passwords as described earlier in this chapter.
If you do not have physical access to the switch, you will need Manager-Level
access:
1. Enter the console at the Manager level.
2. Go to the Set Passwords screen as described above.
3. Select Delete Password Protection. You will then see the following prompt:
Continue Deletion of password protection? No
4. Press the Space bar to select Yes, then press

.
5. Press

to clear the Password Protection message.
To Recover from a Lost Manager Password: If you cannot start a con-
sole session at the Manager level because of a lost Manager password, you
can clear the password by getting physical access to the switch and pressing
and holding the Clear button for a minimum of one second. This action deletes
all passwords and usernames (Manager and Operator) used by both the
console and the web browser interface.
CLI: Setting Passwords and Usernames
Commands Used in This Section
Configuring Manager and Operator Passwords.
Syntax:
[ no ] password <manager | operator > [ user-name ASCII-STR ]
[ no ] password < all >
Figure 1-2. Example of Configuring Manager and Operator Passwords
password See below.
Password entries appear
as asterisks.
You must type the
password entry twice.
!FishSecurity.book Page 5 Thursday, October 10, 2002 9:19 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve Switch 2650 and is the answer not in the manual?

HP ProCurve Switch 2650 Specifications

General IconGeneral
Switching Capacity13.6 Gbps
Forwarding Rate10.1 Mpps
LayerLayer 2
Form FactorRack-mountable
Flash Memory8 MB
Jumbo Frame SupportYes
Power SupplyInternal
ManagementWeb, CLI, SNMP
FeaturesVLAN support, IGMP snooping, QoS
Operating Temperature0°C to 45°C (32°F to 113°F)
Operating Humidity15% to 95% (non-condensing)
Ports48 x 10/100
MAC Address Table Size8, 000 entries

Related product manuals